Pct 2m gage installation tape

It is not necessary to remove the tape immediately after gage installation. Use 4 to 6 in [ to mm] of PCT- 2M Gage Installation tape as a carrier to aid in , must be substituted for the gage installation tape. The installation , in determining the most appropriate tool or material for each task in the gage installation process , : micro-measurements vishaypg. Use 4 to 6 in [ to mm] of PCT- 2M Gage Installation tape as a carrier to aid in positioning , be substituted for the gage installation tape.

Lift one end of , adhesive, and the gage installation tape will serve as a temporary moisture barrier during curing. Not recommended as a general-purpose strain gage adhesive. Bond strength increases rapidly during first five minutes. Not recommended as a general-purpose strain.

Transparent, medium. Transparent, medium viscosity. Higher viscosity. Abstract: UPC h Text:. Abstract: No abstract text available Text: [ 2. Thanks for your great post. After long time I have read a detailed post. Waiting for your next post. Earlier this week my new crank arrived ready to instrument.

The above picture is the new crank with V2 Power Meter currently disassembled. This is exactly what I was expecting for two reasons. The first reason being is that the flat back is easy to mount to. Secondly, and more importantly, if a shear gauge is used to measure the drive side arm it can be placed on the inside and is thus protected. Another view is of the non-drive side arm shown below. In V3 the non-drive side arm will not be instrumented.

The torque tube that goes through the bottom bracket is instrumented instead. No wires to be run through the crank, or like Vector or Rotor, both sides do no require batteries, a master and a slave connection and the associated issues. The first thing is to remove the chain rings as they get in the way.

The loctite on the chain rings tend to make them very difficult to start backing off. I was getting some very large flex in my Allen keys. Two socket drivers work best, or a socket driver on the small side and an Allen key on the other.

On that singular polymide backing is 4 strain grids. There has been some confusion caused by power meter manufacturers. A gauge is the grid s on a polymide backing. In this cause this is one strain gauge that has four sensing grids. However for marketing purposes this would be referred to as four strain gauges.

I could use single grid gauges but that is an inherently flawed design that is more time consuming. I used masking tape to mask off the area but when using Vishay Conditioner and sanding with , then , then grit paper destroyed it very quickly. I masked the area with PCT-2M tape instead and continued sanding. This or their MGJ mylar tape works best for masking. After sanding with conditioner, flood the area, wipe with gauze, then flood with neutralizer and scrub with cotton applicators Q-tip with wooden stick until no more metal residue comes up.

Those oils can ruin the glueline.